/**
  @page PWR_STANDBY PWR_STANDBY example
  
  @verbatim
  *************** (C) COPYRIGHT 2020 - 2023 megawin Technology ***************
  * @file    PWR/PWR_STANDBY/readme.txt 
  * @author  megawin Application Team
  * @version V0.1.10
  * @date    05-January-2023
  * @brief   Description of the PWR PWR_STANDBY example.
  ******************************************************************************
  * THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE
  * TIME. AS A RESULT, MEGAWIN SHALL NOT BE HELD LIABLE FOR ANY DIRECT,
  * INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM
  * THE CONTENT OF SUCH FIRMWARE AND/OR THE USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.
  ******************************************************************************
   @endverbatim

@par Example Description 

This example describes how to enters the system to STANDBY mode and wake-up from this mode.

In this example, Main clock is from PLL clock and it is configured at 72MHz. The PLL clock is based on 12MHz HSE. APB1 and APB2 clock is from Main clock.

This example turns on LED1, waits for a period of time and then enables the WKUP pin and enters the STANDBY mode.
The system enters STANDBY mode causing the LED1 turns off.
Than can wake-up STANDBY mode by pressing a button connected to the WKUP pin or a RESET button.
After wake-up from STANDBY mode, program execution restarts in the same way as after
a RESET, the RTC configuration (clock source, prescaler,...) is kept and LED1 restarts
toggling. As result there is no need to configure the RTC.


@par Directory contents 

  - PWR/PWR_STANDBY/PWR_STANDBY.uvprojx     MDK5 project file
  - PWR/PWR_STANDBY/PWR_STANDBY.uvoptx      MDK5 project options file
  - PWR/PWR_STANDBY/JLinkSettings.ini       Jlink settings file
  - PWR/PWR_STANDBY/main.c                  Main program


@par Hardware and Software environment 

  - Hardware environment
    - HSE crystal is 12MHz
    - The chip pins are connected as follows：
      - PB14 pin is connected to LED1
      - PA0 pin is connected to KEY1


@par How to use it ? 

In order to make the program work, you must do the following :
 - Open PWR_STANDBY.uvprojx from this example folder by Keil MDK5
 - Rebuild all files and load your image into target memory
 - Run the example 
   
 * <h3><center>&copy; COPYRIGHT 2020 - 2023 megawin Technology</center></h3>
 */
