/**
  @page DMAC_MemoryToUart_MultiBlock DMAC_MemoryToUart_MultiBlock example
  
  @verbatim
  *************** (C) COPYRIGHT 2020 - 2023 megawin Technology ***************
  * @file    DMAC/DMAC_MemoryToUart_MultiBlock/readme.txt 
  * @author  megawin Application Team
  * @version V0.1.10
  * @date    05-January-2023
  * @brief   Description of the DMAC DMAC_MemoryToUart_MultiBlock example.
  ******************************************************************************
  * THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE
  * TIME. AS A RESULT, MEGAWIN SHALL NOT BE HELD LIABLE FOR ANY DIRECT,
  * INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM
  * THE CONTENT OF SUCH FIRMWARE AND/OR THE USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.
  ******************************************************************************
   @endverbatim

@par Example Description 

This example describes how to use DMAC to transfer data from Memory to UART cyclically.

In this example, Main clock is from PLL clock and it is configured at 72MHz. The PLL clock is based on 12MHz HSE. APB1 and APB2 clock is from Main clock.

In this example, memSrc is used as the source of DMA transfer, UART2->THR is used as the target of DMA transfer, and DMAC2 Channel 0 enables the automatic source reload function.
Whenever a Block transfer is completed, the source address will be reloaded, so that the transfer from Memory to UART is continuous.
When this example runs, it will print out relevant information through UART1, and enter any character to start DMA transmission.
Then UART2 will continuously send out "Hello world!!!".


@par Directory contents 

  - DMAC/DMAC_MemoryToUart_MultiBlock/DMAC_MemoryToUart_MultiBlock.uvprojx  MDK5 project file
  - DMAC/DMAC_MemoryToUart_MultiBlock/DMAC_MemoryToUart_MultiBlock.uvoptx   MDK5 project options file
  - DMAC/DMAC_MemoryToUart_MultiBlock/JLinkSettings.ini                     Jlink settings file
  - DMAC/DMAC_MemoryToUart_MultiBlock/main.c                                Main program


@par Hardware and Software environment 

  - Hardware environment
    - HSE crystal is 12MHz
    - UART1 (PA9, PA10) is connected to PC serial port
    - UART2 TX (PA2) is connected to PC serial port


@par How to use it ? 

In order to make the program work, you must do the following :
 - Open DMAC_MemoryToUart_MultiBlock.uvprojx from this example folder by Keil MDK5
 - Rebuild all files and load your image into target memory
 - Run the example 
   
 * <h3><center>&copy; COPYRIGHT 2020 - 2023 megawin Technology</center></h3>
 */
